Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 111)

Page 102 Power Equipment Usage Manual (Rev. 5/10)

20. ROUTER, TABLE (Rockler JessEm Route-R-Lift Table) & (Clincher Fence Machine Table

with Jointech Smartfence Plus CL-18)

The router inside the Rockler JessEm Route-R-Lift Table & Fence system has a more powerful motor. Use

this router for large bits to ensure you do not burn up the router motor. It has a basic movable fence.

The router with the Clincher Fence Machine Table with Jointech Smartfence Plus CL-18 has a smaller

motor, but has a precision adjustable fence system. This router uses the same type lift table.

A third router table, also with the Clincher Fence Machine Table with Jointech Smartfence Plus CL-18 is

identical to its lookalike.

20.1. Safety Precautions

a. INSPECT router bits for damage prior to use.

b. LARGER BITS run at slower speeds and require more HP.

c. NEVER touch router bits after use, as they may be extremely hot.

d. MAKE all adjustments with the router power switch in the OFF position, bit stopped and

router unplugged.

e. DO NOT bottom out the bit in the collet or partially insert the bit. Instead, completely insert the

bit, then back off approximately 3/8” to 1/2“ and tighten collar securely.

f. NEVER start the router with the bit in contact with the stock.

g. KEEP workpiece against the fence or bit collar during cutting operation.

h. USE FEATHERBOARDS to support the workpiece against the router table.

i. DO NOT force workpiece into router bit.

j. KEEP hands and fingers 2” from bit.

k. ALWAYS feed material from the right side of the bit to the left side of the bit for cutting the

outside edge of a workpiece.

l. ALL BITS in the Woodshop will require three to five passes dependent upon the type and size of

the bit. Raise bit in 1/8” increments.

m. TAKE LIGHT CUTS. Heavy cuts invite kickback. If necessary, move the fence closer to the bit or

switch to a larger guide bearing.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 111