Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 116)

Page 107 Power Equipment Usage Manual (Rev. 5/10)

21.2.5. Routing the Workpiece

Normally, you feed a router opposite to rotation direction. This gives you just

enough resistance to maintain control and avoid kickback.

When feeding a workpiece into the spinning bit of the router, you want to choose the direction that

forces the bit to push the wood back against you. This direction changes depending on whether the bit

is above or below the workpiece.

a. Bit BELOW workpiece:

• If the BIT is setup to cut BELOW the workpiece, feed from LEFT to RIGHT.

• Stock to be routed should move over the top of the bit using push pads to securely hold

workpiece and protect your fingers.

b. Bit ABOVE workpiece:

• If the BIT is setup to cut ABOVE the workpiece, feed from RIGHT to LEFT.

• Be extra careful not to run your fingers under the spinning bit – keep a safe distance

between your fingers and the bit.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 116