Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 118)

Page 109 Power Equipment Usage Manual (Rev. 5/10)

23. SANDER, 1” BELT/8” DISK (Delta Model SA180)

The Woodshop has two of these machines.

23.1. Safety Precautions

a. DO NOT use sander on metal products.

b. MAKE SURE the sanding belt is tracking correctly.

c. MAKE SURE the sanding belt is not torn or loose.

d. ALWAYS HOLD work firmly when sanding.

e. NEVER TURN THE MACHINE “ON” with the workpiece

contacting the abrasive surface. Kickback can occur.

f. AVOID AWKWARD OPERATIONS AND HAND POSITIONS.

A sudden slip could cause a hand to move into the abrasive disc or belt.

g. DO NOT SAND very small or very thin workpieces that cannot be safely controlled. Loss of

control of the workpiece can result in injury.

h. PROPERLY SUPPORT LONG OR WIDE WORKPIECES. Loss of control of the workpiece is

dangerous.

i. NEVER PERFORM LAYOUT, ASSEMBLY, OR SET-UP WORK on the table/work area when the

machine is running. A sudden slip could cause a hand to move into the abrasive surface. Severe

injury can result.

23.2. Setup & Use – Belt/Disk Sander

Finish curves or odd-shaped work by removing the belt plate.

You can sand chamfers and bevels by tilting the aluminum tables on either the belt or disk sander.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 118