Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 123)

Page 114 Power Equipment Usage Manual (Rev. 5/10)

27.2. Setup & Use – Wide Drum Sander

The sander is to be used on HARDWOODS only. Do not use the sander on PINE, SPRUCE, FIR, PAINTED

WOOD, TREATED WOOD, PLYWOOD or any other soft wood as these will leave material on the

abrasive sanding belt and may negatively impact the project the next Woodshop member sands.

Further, GLUE-UPS must be scraped before sanding and they must be allowed to cure overnight before

running them through the sander. It is also advisable to use the planer before using the sander on glue-

ups. Glue that has not properly cured will be transferred to, and will cause severe damage to, the

sanding belt.

27.2.1. Turn-On Procedure

a. Unlock the electrical switch box, and turn power ON. (See Shop Monitor for key)

b. Connect the black air hose and verify pressure is set to 85-90 lbs.

c. CLOSE Main Vacuum Vent at top of unit.

d. Open side access panel – Activate air pressure on Sanding Belt by pulling down on blue collar –

Close access panel.

e. Open Main Vacuum Vent at top of Unit.

f. Place wood piece with spacer on top of in-feed table under the Red Bar. Use the Depth Wheel

below side access panel to raise or lower in-feed table until spacer makes slight contact with

Red Bar.

g. Remove spacer and workpiece.

h. Press the Red STOP button to reset – Press the Green START button to start.

i. Insert workpiece:

• Always feed the wood so the sanding is with the grain.

• Do Not Force-Feed the workpiece through the machine, let sander apply proper feed rate.

• You can adjust the conveyor feed speed on the sander with the round dial located to the

lower left side of the front. Set dial at approximately 1/4 turn, around the 45 minute mark

on a clock.

i. Turn Depth Wheel counter-clockwise no more than 1/4 turn for each subsequent pass until

desired result is obtained.

27.2.2. Turn-Off Procedure

a. Press Red STOP button.

b. CLOSE Main Vacuum Vent at top of Unit.

c. Open side access panel – Release air pressure on sanding belt by pulling down on blue collar –

Close access panel.

d. Turn Main Power Switch to OFF and lock.

e. Clean/vacuum any residual dust from the equipment and surrounding area.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 123