Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 124)

Page 115 Power Equipment Usage Manual (Rev. 5/10)

28. SANDER, DRUM (Ryobi WDS1600)

28.1. Safety Precautions

You need to be careful to not stick your fingers into the sander.

a. DO NOT SAND MATERIAL thicker than 6”, shorter than 6”, narrower

than 3/4” or thinner than 1/8” thick.

b. DO NOT SAND very small or very thin workpieces that cannot be safely

controlled. Loss of control of the workpiece can result in injury. If a

workpiece is thinner than 1/8”, you must use a backer board when

sanding.

c. NEVER stand directly in line with either the infeed or outfeed sides.

Stand to one side.

d. NEVER TURN THE MACHINE “ON” with the workpiece contacting the abrasive surface. Kickback

can occur.

e. AVOID AWKWARD OPERATIONS AND HAND POSITIONS – NEVER place your hands directly at the

front opening of the infeed. A sudden slip could cause a hand to move into the abrasive disc or

belt.

f. PROPERLY SUPPORT LONG OR WIDE WORKPIECES. Loss of control of the workpiece is

dangerous.

g. NEVER PERFORM LAYOUT, ASSEMBLY, OR SET-UP WORK on the table/work area when the

machine is running. A sudden slip could cause a hand to move into the abrasive surface. Severe

injury can result.

28.2. Setup & Use – Drum Sander

TIP: lift the lid on this sander and note if there are any burn marks. If there are,

don’t feed your wood where those burn marks are.

The grit of the belt is 80, which is the grit we have on all the stationery sanders.

The sander is to be used on HARDWOODS only. Do not use the sander on PINE, SPRUCE, FIR, PAINTED

WOOD, TREATED WOOD, PLYWOOD or any other soft wood as these will leave material on the

abrasive sanding belt and may negatively impact the project the next Woodshop member sands.

Further, GLUE-UPS must be scraped before sanding and they must be allowed to cure overnight before

running them through the sander. It is also advisable to use the planer before using the sander on glue-

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 124