Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 125)

Page 116 Power Equipment Usage Manual (Rev. 5/10)

up. Glue that has not properly cured will be transferred to, and will cause severe damage to, the

sanding belt.

It is best with this sander to start with your piece on the side away from the motor housing, and then

move it towards the housing and sand again. Depending on the width of your wood, you can do this

several times before you lower the drum. If you do this, you can lower the drum more than the 1/4

turn. Remember to avoid feeding the wood where there are burn marks on the sanding belt.

a. Set the speed (round knob you twist) to 4 or a little less [never faster].

b. Turn the large hand-wheel until you can feel the belt touch the wood.

c. Turn the sander on (flip switch to towards the wall).

d. Start your wood through and lower the drum until you hear it sand the wood.

e. Send the wood through again.

f. If you need more sanding, lower the drum 1/8th to 1/4th turn (1/8th turn if the wood is over 2”

wide, 1/4th turn if the wood is less than 2” wide) and start the wood again.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 125