Page i Power Equipment Usage Manual (Rev. 5/10)
ACKNOWLEDGEMENTS
This manual was prepared by the members of the 2008 Safety Committee:
Dave Young, Randy Pensabene, Roger Tripp, Irv Turnbull, Ted Girvan
Additional contributors to this manual include:
Ray Hohenberger, Jerry Sivin, Bill Hartmann, Dick Gelbaugh,
Larry Mart, David Freiborg, Bill Neal, Don Webster
REVISIONS
All suggested changes, edits and/or additions to this document should be submitted in writing by one of
the following methods:
a. Email changes, edits and/or additions (please be specific) to
:
"Sun City Texas Woodworkers Club" <Sun_City_Texas_Woodworkers_Club@mail.vresp.com>
b. Bring a hardcopy or computer disk to the Woodshop and give it to the Shop Monitor.
• This can be either, pages marked up in RED (please) from this manual, or new written
material.
• Please also provide your name and contact information in case there are any questions.
• Notify the following that it is there for pickup, or be sure to clearly mark the front with
“EQUIPMENT MANUAL EDITS” so that it will be noticed:
"Sun City Texas Woodworkers Club" <Sun_City_Texas_Woodworkers_Club@mail.vresp.com>
Woodshop Board of Directors,
Roy McDonald
thickness or use backer board
• Section 7 Table Saw: Added section on kickback and
how to prevent
• Section 22 Router Table: Added the new/third
router table to existing section
• Section 23 Edge Router Table: New section for new
equipment
• Section 27 Edge Sander: New section for new
equipment
• Section 30 Drum Sander: Safety – revised
Woodshop Board of Directors
Bill Thornton
Commentaires sur ces manuels