Ryobi DBJ50 Instructions d'exploitation Page 37

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 139
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 36
Page 28 Power Equipment Usage Manual (Rev. 5/10)
RIP CUT: If you allow the stock to twist or skew, as soon as it
reaches the back edge of the blade, the up-running teeth will
launch it at you, in the direction of the blade rotation (red
arrow).
(Kickback diagrams courtesy of: http://www.raygirling.com/kickback.htm)
7.3. Setup – Table Saw
The setup and operation for all three table saws are essentially the same.
7.3.1. Changing the Blade
Disconnect machine from power source.
Remove table insert and raise the saw blade to its
maximum height, then remove arbor nut and collar.
Install blade, making sure the cutting teeth at the
top of the blade point toward the front of the saw.
Slide the collar on to the arbor and start the arbor
nut on the threads. (NOTE: Righthand threads; turn
clockwise to tighten.) Snug the arbor nut against the collar and blade with the provided arbor
wrench, while holding blade with thumb and finger tips.
Wedge a block of wood between the blade and table to prevent blade rotation, then tighten the
arbor nut securely with the arbor wrench.
Replace the table insert.
7.3.2. Blade Raising and Tilting
The front handwheel (A) controls the raising and
lowering of the blade.
The side handwheel (B) controls blade tilt, which is
indicated by the scale (C). The blade tilting
mechanism allows the blade to be tilted up to 45° to
Vue de la page 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 138 139

Commentaires sur ces manuels

Pas de commentaire