Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 38)

Page 29 Power Equipment Usage Manual (Rev. 5/10)

the LEFT for the Powermatic and 45° to the RIGHT for the Delta.

• The lock knobs (D) are used to lock the setting of the handwheels. (NOTE: Only a small amount

of force is required to lock the mechanism securely. Any added force merely puts unnecessary

strain on the locking device.)

7.3.3. Installing Splitter Guard Assembly

• Place the two flanges of the splitter

assembly onto the screws as shown.

• Snug the screws.

NOTE: Make sure the front shield

faces in toward the blade.

7.3.4. Miter Gauge Adjustment

• Slide the miter gauge into one of the slots

on the table top.

• The miter gauge is equipped with index

stops at 90 degrees and 45 degrees right

and left.

• To operate the miter gauge, loosen lock

handle (B) and move the body of the miter

gauge (C) to the desired angle. The miter

gauge body is set to stop at 0 degrees and

45 degrees left or right. To move the miter

gauge beyond these points, the stop rod

(D), must be pulled out.

• If accurate crosscutting work is to be done using the miter gauge, check its squareness to the

slot with a square as shown. Re-adjust the stop position as required.

7.3.5. Conditions Which Can Cause Kickbacks (See also 7.2)

Serious injury can result from kickbacks which occur when a work piece binds on the saw blade or binds

between the saw blade and rip fence or other fixed object. This binding can cause the work piece to lift

up and be thrown toward the operator. Listed below are the conditions which can cause kickbacks:

• Releasing the workpiece before completing the operation or not pushing the workpiece all

the way past the saw blade.

• Confining the cutoff piece when crosscutting or ripping.

Hex Screw

Hex Nut

Front

Shield

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 38