Ryobi DBJ50 Instructions d'exploitation Page 67

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 139
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 66
Page 58 Power Equipment Usage Manual (Rev. 5/10)
12. SAW, TABLE – (3 ¼” Microlux 80463)
Even though this is smaller than the machines on the general shop floor, all the
same precautions apply. This machine can cut you and give you kickbacks just as
much as the saws on the floor.
12.1. Safety Precautions
a. CHECK the BLADE for sharpness and secure fastening to
the arbor before machine is turned on.
b. ADJUST BLADE height so it is approximately 1/8” above the
surface of the wood being cut.
c. KEEP HANDS out of the path of saw blade.
d. NEVER REACH around the blade while it is running.
e. BE SURE to keep workpiece securely against the miter gauge or fence.
f. SHOULD ANY PIECES GET CAUGHT in the blade guard or in the slot in the table top, turn off saw
and unplug cord before removing.
g. IF THE BLADE SLOWS down while cutting, you are feeding too fast.
h. WHEN CROSS CUTTING:
Remove rip fence and ALWAYS USE MITER GAUGE.
Hold the wood securely against the face of the miter gauge with one hand. Grasp the
miter gauge lock knob with the other hand, keeping your hand away from the blade.
To support extra long stock when cross cutting, pull out the table extension and swing
extension support leg down.
i. WHEN RIPPING:
Remove miter gauge and ALWAYS USE THE RIP FENCE.
If the wood does not have a straight edge to ride along the rip fence it can bind and
cause a kickback.
Use two push sticks, one in each hand, to push short or narrow workpieces past the
blade. Use one stick to push the stock and hold it down to the table. Use the other push
stick to hold the stock against the fence.
Vue de la page 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 138 139

Commentaires sur ces manuels

Pas de commentaire