Ryobi DBJ50 Instructions d'exploitation Page 68

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 139
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 67
Page 59 Power Equipment Usage Manual (Rev. 5/10)
12.2. Setup & Use – 3 ¼” Table Saw
This saw can be used for either CROSSCUTS or RIPCUTS.
Features:
Variable speed, from 3,600 to 7,000 rpm
Tilting arbor for angle cuts up to 45 degrees
While it can cut a full 1” at 90 degrees and 3/4" at 45 degrees, our preference is that only wood
1/2" or thinner be cut on this saw and that the blade be kept at 90 degrees
Blade: 80 tooth fine cut, 3-1/4” diameter, 10mm hole
Blade height adjusts from 0 to 1“
11-1/2” x 9-1/2” table with 9-1/2” x 9-1/2” machined aluminum surface
Calibrated miter gauge and 2 miter gauge slots for cutting from left or right side of blade
The fence on this saw is different than the fences on the bigger saws. On this saw, you set the fence in
position, screw down the front of it, and then screw down the clamp on the back. If you don’t secure
both the front and the back you will not get straight cuts and you will increase the risk of kickback.
The guard on this saw is also less capable than on the bigger saws. Most often, you will have to remove
the guard to use this saw. Thus the risk of kickback is high.
In all other respects, this is just a smaller version of the larger table saws and one should look at Section
7. Table Saw for more information.
Vue de la page 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 138 139

Commentaires sur ces manuels

Pas de commentaire