Ryobi DBJ50 Instructions d'exploitation Page 70

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 139
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 69
Page 61 Power Equipment Usage Manual (Rev. 5/10)
Use the largest size biscuit when working with large projects, as this will provide the greatest amount of
strength to the joint. In most cases, use #20 biscuits, but when working on narrower material, switch to
smaller biscuits where appropriate.
13.3. Setup & Use – Biscuit Cutter
Practice Cuts Highly Recommended! After each set-up or adjustment to the tool,
make several practice cuts in scrap material to verify desired operation.
13.3.1. To Start & Stop Tool
a. Connect tool to power circuit.
b. Grip tool firmly to resist starting torque, and
squeeze trigger switch (A) Figure 1, to START
tool.
c. Release trigger switch to STOP tool.
d. Switch Lock: the trigger switch may be locked in
the “ON” position as follows:
Squeeze trigger switch to START motor and depress lock button (B) Figure 1, while releasing
trigger switch. Release lock button.
To STOP tool: squeeze trigger switch and release, while leaving lock button free to spring
out.
13.3.2. Adjusting Depth of Groove
A quick setdepth adjusting turret (A) Figure 2, provides for
quick changes in depth of cut to accommodate the various
sizes of available biscuits and other accessories. To set depth
of cut: rotate depth adjusting turret until desired size marking
on turret aligns with the index mark (B) Figure 2. The
following depth settings are provided:
0 For “0” size biscuits
10 For “10” size biscuits
20 For “20” size biscuits
13.3.3. Height Adjustment using Adjustable Fence
See Figure 3 and Figure 4:
a. Loosen locking knob (A), and rotate knob (B) to position the fence as desired, (rotate knob
clockwise to raise fence, rotate knob counterclockwise to lower fence).
Vue de la page 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 138 139

Commentaires sur ces manuels

Pas de commentaire