Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 75)

Page 66 Power Equipment Usage Manual (Rev. 5/10)

easiest way is to squirt some glue into the slot and then run a glue brush through the slot until

the glue is evenly coated on all surfaces.

j. Use clamps to hold the joint while the glue dries, but take care that you don't tighten the clamps

so much that you squeeze all of the glue out of the joint.

k. Remove dust from the dust bag.

13.3.7. Corner Joints

a. Layout groove positions as described in Section 15.3.5

Positioning Grooves for Biscuits.

b. Set depth stop turret to desired biscuit size.

c. Set the tilt fence to the 90° position (see Section 15.3.4 Angle

Adjustment).

d. Set fence height adjustment to desired height (usually 1/2

the material thickness), (see Section 15.3.3 Height

Adjustment).

e. Clamp the workpiece securely.

f. Position tool to workpiece with bottom of fence resting on

workpiece. Align guide notch (A) or (B) Figure 12, with a groove centerline. Apply pressure to

auxiliary handle (C) Figure 12, to keep the front of tool and fence in firm contact with workpiece.

g. Hold tool firmly as shown in Figure 13, squeeze trigger

switch to start tool.

h. At a slow, steady pace, push tool forward in base as far

as depth stop allows.

i. Release trigger switch to stop tool and remove tool

from work.

j. Repeat steps f. through i. until all grooves for this joint

are completed.

k. When finished, remove dust from the dust bag.

NOTE: Assemble all joints and verify alignments before applying glue (see Figure14 ).

Fig.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 75