Ryobi DBJ50 Instructions d'exploitation Page 76

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 139
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 75
Page 67 Power Equipment Usage Manual (Rev. 5/10)
13.3.8. Surface (“T”) Joints
a. Layout groove positions as described in Section 15.3.5
Positioning Grooves.
b. Set depth stop turret to desired biscuit (or other
accessory), size.
c. Mark centerline of joint on workpiece “A” (see Figure 15).
d. Clamp a straight edge guide to the workpiece, 3/8" back
from the joint centerline (as marked in Step 2). Clamp
workpiece securely (see Figure 16).
e. Set tilt fence to 0° position (see Section 15.3.4 Angle
Adjustment).
f. Position tool to workpiece with bottom of base against
straight edge and guide notch (C) Figure 17, aligned with a
groove centerline. Apply pressure to auxiliary handle (D)
Figure 17 to hold tool firmly in place.
g. Hold tool firmly as shown in Figure 13. Squeeze trigger
switch to start tool.
h. At a slow, steady pace, push tool forward in base as far
as depth stop allows.
i. Release trigger switch to stop tool and remove tool
from work.
j. Repeat steps e. through g. until all the grooves in
workpiece “A” are completed.
k. Follow steps c. through j. of Section 15.3.7 Corner Joints to
complete required grooves in workpiece “B” Figure 15.
NOTE: Assemble all joints and verify alignments before
applying glue (see Figure 18).
Fig.
15
Fig.
16
Fig.
17
Fig.
18
Vue de la page 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 138 139

Commentaires sur ces manuels

Pas de commentaire