Ryobi DBJ50 Instructions d'exploitation Page 85

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 139
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 84
Page 76 Power Equipment Usage Manual (Rev. 5/10)
16. LATHE, WOOD (20” Powermatic 3520B & 14” Jet Mini Lathe JML-1014)
(NOTE: Portions of the information presented in this section were taken from the Powermatic & Jet
Operating Manuals.)
The Woodshop has two woodturning lathes. The smaller Jet lathe is suitable for turning pens, small
bowls, and craft projects. The Powermatic lathe is a professional machine capable of turning pieces up
to 20” in diameter and 3 feet long. Both lathes share all the accessories needed for almost any
woodturning project.
Neither lathe is covered in the Woodshop Orientation Class, therefore:
To operate the large Powermatic lathe you are required to complete the Woodshop training
class. See the Shop Monitor for the key to the Powermatic; they will verify you are on the
“Approved Users” list.
The Jet mini lathe is available to all Woodshop members. However, it is highly recommended
that you get trained on this lathe by contacting the Woodturning group.
Be sure you are prepared for the task at hand, start slowly and gain confidence as you turn your project.
16.1. Safety Precautions
Adherence to these Safety Precautions, enforced from the outset, will become
habit and your wood turning will consistently be a safe and enjoyable experience.
a. EXAMINE WORKPIECE for flaws and test glue joints
before placing workpiece in lathe. Do not attempt
to turn cracked or split wood, or wood with loose
knots.
b. KEEP guards in place.
c. USE SAFETY EQUIPMENT. Always wear eye and face
protection, and a dust mask is highly advised.
d. ROUGH CUT THE WORKPIECE as close as possible to
the finished shape before installing it on the
faceplate.
e. MAKE SURE the tool rest is adjusted properly. Keep the tool rest as close to the work as possible.
NEVER adjust tool rest while work is turning.
f. ROTATE workpiece by hand to check clearance and examine workpiece setup carefully prior to
engaging power.
Vue de la page 84
1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 138 139

Commentaires sur ces manuels

Pas de commentaire