Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 88)

Page 79 Power Equipment Usage Manual (Rev. 5/10)

16.5. Setup & Use – 14” Jet Mini Lathe

16.5.1. Tailstock Movement

• Tailstock Handwheel (A, Figure 2) – Turn clockwise to

move tailstock spindle forward. Turn counterclockwise

to retract tailstock spindle.

• Tailstock Spindle Lock (B, Figure 1) – Locks tailstock

spindle. Release to adjust with handwheel.

• Tailstock Lock (C, Figure 1) – Locks tailstock in position

on the bed. Release to move the tailstock assembly

closer to or farther from the headstock.

• The tailstock spindle is hollow. This can be useful for

inserting a long bit to drill a hole in the center of a

workpiece on the face plate.

16.5.2. On/Off Switch

(Figure 2) – Has a safety feature to prevent unauthorized use;

pull out the upper piece of the switch and store in a safe

place. The piece must be re-inserted to operate the lathe.

16.5.3. Spur Center

(Figure 3) – Slides into headstock and holds the workpiece

during spindle turning.

WARNING: Thoroughly clean the taper on the spur center and

the inside of the headstock spindle before mounting the spur

center. Failure to do so may result in separation of the two and

possible injury or tool damage.

Figure 1. Tailstock Movement

Figure 2. On/Off Switch

Figure

Spur Center

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 88