Ryobi DBJ50 Instructions d'exploitation Page 93

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 139
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 92
Page 84 Power Equipment Usage Manual (Rev. 5/10)
16.6.7. Centers – Installing and Removing
a. Disconnect Lathe from power source.
b. To install a spur center or live center (the spur center
should first be mounted to your workpiece; see under
“Operation” for more details), clean the tapered end of
the center and the inside of the headstock taper
spindle, then push the center into the headstock
spindle.
c. To remove a spur center or live center, first remove the
workpiece from the Lathe. Insert the knockout rod
(Figure 17) through the hole in the handwheel and
firmly tap the tapered end of the spur center. The
sliding collar on the knockout rod helps give the
necessary impact without having to use a mallet against
the end of the rod.
IMPORTANT: Hold the center by either placing your
thumb and forefinger on the outside diameter of the
spur center, or wrapping the center with a rag. The
center can be damaged if allowed to fall.
16.6.8. Face Plate – Installing and Removing
a. Disconnect Lathe from power source.
b. Mount the face plate to your bowl blank.
c. Push in the spindle lock button (Figure 18) and rotate
the handwheel slightly until the spindle locks. Keep the
spindle lock button pushed in.
d. Install the face plate onto the threads of the headstock
spindle and rotate clockwise hand-tight. When the
Lathe is turned on (forward rotation), the rotational
force will snug the face plate even further onto the
threads.
WARNING: If at any time you will be reversing spindle
rotation, make sure the two set screws in the face plate
are tight! One of these is shown in Figure 19. Failure to
do this may cause the face plate to loosen from the
headstock spindle.
Figure
17
.
Centers
-
Install/Remove
Figure
18
.
Faceplate
-
Install/Remove
Figure
19
.
Faceplate
-
Install/Remove
Vue de la page 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 138 139

Commentaires sur ces manuels

Pas de commentaire