Ryobi MS181 Manuel de l'opérateur télécharger pdf (Page 16)

Page 16

ADJUSTMENTS

TO INSTALL BLADE

See Figures 15, 16, 17 and 18.

DANGER:

A 8-1/4 in. (209.6 mm) blade is the maximum blade

capacity of your saw. Never use a blade that is too

thick to allow outer blade washer to engage with

the flats on the spindle. Larger blades will come in

contact with the blade guards, while thicker blades

will prevent the blade bolt from securing the blade

on the spindle. Either of these situations will result

in a serious accident and can cause serious

personal injury.

■ Remove battery pack from saw.

WARNING:

Failure to remove battery pack from your saw could

result in accidental starting causing possible serious

personal injury.

■ Push down on the saw arm and pull out the lock

pin to release saw arm. Raise saw arm to its full

raised position. Be cautious, saw arm is spring

loaded to raise.

■ Loosen the phillips screw on the blade bolt

cover until blade bolt cover can be raised.

See Figure 15.

■ Gently raise the lower blade guard bracket,

releasing lower blade guard from notch so that

lower blade guard and blade bolt cover can be

rotated up and back to expose the blade bolt.

See Figure 16.

LOWER BLADE

GUARD BRACKET

Fig. 16

LOWER

BLADE GUARD

NOTCH

PHILLIPS SCREW

PHILLIPS

SCREW

BLADE BOLT

Fig. 17

LOWER

BLADE GUARD

PHILLIPS

SCREW

BLADE

BOLT COVER

INNER BLADE

WASHER WITH

DOUBLE "D" FLATS

BLADE

OUTER BLADE WASHER

WITH DOUBLE "D" FLATS

BLADE BOLT

TIGHTEN

LOOSEN

BLADE BOLT COVER

3 0

31.62

Fig. 15

FLAT (S)

ON SPINDLE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi MS181 Manuel de l'opérateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi MS181