search

Ryobi MS181 Manuel de l'opérateur Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
Page 18
0
1 5
3 0
4 5
1 5
3 0
4 5
31.62
22.5
3
1
.6
2
Note: Many of the illustrations in this manual show
only portions of your compound miter saw. This is
intentional so that we can clearly show points being
made in the illustrations. Never operate your saw
without all guards securely in place and in good
operating condition.
SQUARING THE MITER TABLE
TO THE FENCE
See Figures 19 – 22.
■ Remove battery pack from saw.
WARNING:
Failure to remove battery pack from your saw
could result in accidental starting causing possible
serious personal injury.
■ Push down on the saw arm and pull out the lock
pin to release the saw arm.
■ Raise saw arm to its full raised position.
■ Lift the miter table clamp.
■ Rotate the miter table until the pointer is posi-
tioned at 0°.
■ Push the miter table clamp back down.
■ Lay a framing square flat on the miter table. Place
one leg of the square against the fence. Place the
other leg of the square beside the throat plate in
the miter table. The edge of the square and the
throat plate in the miter table should be parallel as
shown in figure 19.
Fig. 20
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
MITER TABLE
FENCE
FRAMING
SQUARE
MITER TABLE
FENCE
FRAMING
SQUARE
THROAT PLATE
Fig. 19
VIEW OF MITER TABLE SQUARE WITH
FENCE AND CORRECTLY ADJUSTED
MITER
TABLE CLAMP
Fig. 21
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
ADJUSTMENTS
0
1 5
3 0
4
5
1 5
3 0
4
5
22.5
31.62
22.5
3
1
.6
2
THROAT PLATE
0
1 5
3 0
4 5
1 5
3 0
4 5
31.62
22.5
22.5
3
1
.6
2
THROAT PLATE
MITER TABLE
FENCE
FRAMING
SQUARE
■ If the edge of the framing square and the throat
plate in the miter table are not parallel as shown
in figures 20 and 21, adjustments are needed.
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Commentaires sur ces manuels

Pas de commentaire
Produits connexes et manuels pour Scies à onglets Ryobi MS181
Scies à onglets Ryobi TS1550 Manuel de l'opérateur   (26 pages)
Scies à onglets Ryobi TS230 Manuel de l'opérateur   (28 pages)
Scies à onglets Ryobi TS1351 Manuel de l'opérateur   (28 pages)
Scies à onglets Ryobi TSS120L Manuel d'utilisation et d'entretien    (104 pages)
  • Ledino GAF Paradise 888 Digital Chisholm
  • Belkin Serveurs d'impression Kompernass Toasters RCA Téléphones IP Misfit Non HP Bandes de données vierges
  • Liebherr GX 823 Comfort Acer AO531h Aeg-Electrolux B9971-5-M Acer TravelMate 8531 Renault 2012 Clio
  • AEG S60240DT28 Manuel de l'utilisateur Panasonic DMREX75 Instructions d'exploitation Zanussi ZRB33100XA Manuel de l'utilisateur Lenovo S8-50F Guide de l'utilisateur Backcountry Access Tracker DTS Manuel du propriétaire