Ryobi MS181 Manuel de l'opérateur télécharger pdf (Page 19)

Page 19

31.62

22.5

31.62

22.5

ADJUSTMENTS

SQUARING THE SAW BLADE TO THE FENCE

See Figures 23 – 26.

■ Remove battery pack from saw.

WARNING:

Failure to remove battery pack from your saw

could result in accidental starting causing possible

serious personal injury.

■ Pull the saw arm all the way down and engage

the lock pin to hold the saw arm in transport

position.

■ Lift the miter table clamp.

■ Rotate the miter table until the pointer is posi-

tioned at 0°.

■ Push the miter table clamp back down.

■ Lay a framing square flat on the miter table. Place

one leg of the square against the fence. Slide the

other leg of the square against the flat part of saw

blade.

Note: Make sure that the square contacts the flat

part of the saw blade, not the blade teeth.

Fig. 23

MITER TABLE

VIEW OF BLADE

SQUARE WITH FENCE

BLADE

FENCE

Fig. 24

VIEW OF BLADE NOT SQUARE WITH

FENCE, ADJUSTMENTS ARE REQUIRED

■ Using a 6 mm hex key, loosen the socket head

screws securing the fence.

See Figure 22.

Adjust

the fence left or right until the framing square and

throat plate are parallel.

Fig. 22

6 mm SOCKET

HEAD SCREW(S)

FENCE

■ Retighten the screws securely and recheck the

fence-to-table alignment.

FRAMING SQUARE

31.6

4 5

■ If the front or back edge of the saw blade angles

away from the square as shown in figures 24 and

25, adjustments are needed.

FENCE

MITER TABLE

FRAMING SQUARE

BLADE

■ The edge of the square and the saw blade should

be parallel as shown in figure 23.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi MS181 Manuel de l'opérateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi MS181