Ryobi MS181 Manuel de l'opérateur télécharger pdf (Page 20)

Page 20

22.5

31.62

4 5

22.5

4 5

22.5

31.62

22.5

31.62

ADJUSTMENTS

■ Using the 6 mm hex key provided, loosen the

socket head screws that secure the mounting

bracket to the miter table.

See Figure 26.

SQUARING THE BLADE TO THE

MITER TABLE

See Figures 27 – 31.

■ Remove battery pack from saw.

WARNING:

Failure to remove battery pack from your saw

could result in accidental starting causing possible

serious personal injury.

■ Pull the saw arm all the way down and engage

the lock pin to hold the saw arm in transport

position.

■ Lift up the miter table clamp.

■ Rotate the miter table until the pointer is posi-

tioned at 0°.

■ Push the miter table clamp back down.

■ Loosen bevel lock knob and set saw arm at 0°

bevel (blade set 90° to miter table). Tighten bevel

lock knob.

■ Place a combination square against the miter

table and the flat part of saw blade.

Note: Make sure that the square contacts the flat

part of the saw blade, not the blade teeth.

■ Rotate the blade by hand and check the blade-to-

table alignment at several points.

■ The edge of the square and the saw blade should

be parallel as shown in figure 27.

Fig. 27

VIEW OF BLADE SQUARE

WITH MITER TABLE

COMBINATION

SQUARE

FENCE

Fig. 25

VIEW OF BLADE NOT SQUARE WITH

FENCE, ADJUSTMENTS ARE REQUIRED

MITER TABLE

BLADE

FENCE

FRAMING SQUARE

Fig. 26

6 mm

HEX KEY

MITER TABLE

■ Rotate the mounting bracket left or right until the

saw blade is parallel with the square.

■ Retighten the screws securely and recheck the

blade-to-fence alignment.

MOUNTING

BRACKET

6 mm SOCKET

HEAD SCREW(S)

MITER TABLE

BLADE

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi MS181 Manuel de l'opérateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi MS181