Ryobi MS181 Manuel de l'opérateur télécharger pdf (Page 24)

Page 24

CUTTING WITH YOUR COMPOUND

MITER SAW

WARNING:

When using a work clamp or C-clamp to secure

your workpiece, clamp workpiece on one side of

the blade only. The workpiece must remain free on

one side of the blade to prevent the blade from

binding in workpiece. The workpiece binding the

blade will cause motor stalling and kickback. This

situation could cause an accident resulting in

possible serious personal injury.

CROSSCUTTING

See Figure 33.

A crosscut is made by cutting across the grain of the

workpiece. A 90° crosscut is made with the miter table

set at the zero degree position. Miter crosscuts are

made with the miter table set at some angle other

than zero.

4 5

3 0

31.62

OPERATION

90°

CROSSCUT

Fig. 33

Note: You can quickly locate 0°, 22-1/2° left or

right, 30° left or right, and 45° left or right on the

scale. The miter table can be seated in one of the

detent stop notches, located in the miter table

frame.

WARNING:

To avoid serious personal injury, always push the

miter table clamp back down before making a cut.

Failure to do so could result in movement of the

miter table while making a cut.

■ Place the workpiece flat on the miter table with

one edge securely against the fence. If the board

is warped, place the convex side against the

fence. If the concave edge of a board is placed

against the fence, the board could collapse on the

blade at the end of the cut, jamming the blade.

See Figures 40 and 41.

■ When cutting long pieces of lumber or molding,

support the opposite end of the stock with a roller

stand or with a work surface level with the saw

table.

■ Align cutting line on the workpiece with the edge

of saw blade.

■ Grasp the stock firmly with one hand and secure

it against the fence. Use the work clamp or a C-

clamp to secure the workpiece when possible.

See Figure 33.

WARNING:

To avoid serious personal injury, keep your hands

outside the no hands zone; at least 3 in. (8 cm)

from blade. Never perform any cutting operation

freehand (without holding workpiece against the

fence). The blade could grab the workpiece if it

slips or twists.

■ Before turning on the saw, perform a dry run of the

cutting operation just to make sure that no

problems will occur when the cut is made.

■ Grasp the saw handle firmly, depress the lock-off

button, then squeeze the switch trigger. Allow

several seconds for the blade to reach maximum

speed.

■ Slowly lower the blade into and through the

workpiece.

See Figure 33.

■ Release the switch trigger and allow the saw

blade to stop rotating before raising the blade out

of workpiece.

TO CROSSCUT WITH YOUR MITER SAW:

■ Pull out the lock pin and lift saw arm to its full

height.

■ Lift the miter table clamp.

■ Rotate the miter table until the pointer aligns with

the desired angle on the miter scale.

■ Push the miter table clamp back down.

WORK CLAMP

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi MS181 Manuel de l'opérateur Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi MS181