Ryobi MS181 Manuel de l'opérateur télécharger pdf (Page 27)

Page 27

4 5

22.5

1.62

OPERATION

■ Before turning on the saw, perform a dry run of the

cutting operation just to make sure that no problems

will occur when the cut is made.

■ Grasp the saw handle firmly, depress the lock-off

button, then squeeze the switch trigger. Allow sev-

eral seconds for the blade to reach maximum speed.

■ Slowly lower the blade into and through the

workpiece.

See Figures 36 and 37.

■ Release the switch trigger and allow the saw blade

to stop rotating before raising the blade out of

workpiece.

SUPPORT LONG WORKPIECES

See Figure 38.

Long workpieces need extra supports. Supports

should be placed along the workpiece so it does not

sag. The support should let the workpiece lay flat on

the base of the saw and work table during the cutting

operation. Use the work clamp or a C-clamp to secure

the workpiece.

WARNING:

To avoid serious personal injury, always keep your

hands outside the no hands zone; at least 3 in.

(8 cm) from blade. Never perform any cutting

operation freehand (without holding workpiece

against the fence). The blade could grab the

workpiece if it slips or twists.

Fig. 37

° X 45° COMPOUND

MITER CUT

Fig. 38

LONG WORKPIECE

WORKPIECE

SUPPORTS

4 5

1 5

4 5

31.62

22.5

31.62

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi MS181 Manuel de l'opérateur Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi MS181