Ryobi MS181 Manuel de l'opérateur télécharger pdf (Page 6)

Page 6

IMPORTANT SAFETY INSTRUCTIONS FOR

CHARGER

■ SAVE THESE INSTRUCTIONS. This manual

contains important safety and operating

instructions for charger part number 1423701.

■ Before using charger, read all instructions and

cautionary markings in this manual, on charger,

and product using charger.

■ To reduce risk of injury, charge only nickel-

cadmium type rechargeable batteries. Other

types of batteries may burst causing personal

injury and damage.

■ Do not expose charger to wet or damp

conditions.

■ Use of an attachment not recommended or sold

by the charger manufacturer may result in a risk

of fire, electric shock, or injury to persons.

■ To reduce risk of damage to charger and cord,

pull by charger plug rather than cord when

disconnecting charger.

■ Make sure cord is located so that it will not be

stepped on, tripped over, or otherwise subjected

to damage or stress.

■ An extension cord should not be used unless

absolutely necessary. Use of improper

extension cord could result in a risk of fire and

electric shock. If extension cord must be used,

make sure:

a. That pins on plug of extension cord are the

same number, size and shape as those of

plug on charger.

b. That extension cord is properly wired and in

good electrical condition; and

c. That wire size is large enough for AC

ampere rating of charger as specified

below:

Cord Length (Feet) 25' 50' 100'

Cord Size (AWG) 16 16 16

Note: AWG = American Wire Gage

■ DO NOT OPERATE CHARGER WITH A

DAMAGED CORD OR PLUG. If damaged,

have replaced immediately by a qualified

serviceman.

■ Do not operate charger if it has received a

sharp blow, been dropped, or otherwise

damaged in any way; take it to a qualified

serviceman. Following this rule will reduce the

risk of electric shock, fire, or serious personal

injury.

■ Do not disassemble charger; take it to a

qualified serviceman when service or repair is

required. Incorrect reassembly may result in a

risk of electric shock or fire.

■ To reduce risk of electric shock, unplug charger

from outlet before attempting any maintenance

or cleaning. Turning off controls will not reduce

this risk.

■ Do not use charger outdoors.

■ Disconnect charger from power supply when

not in use.

■ SAVE THESE INSTRUCTIONS. Refer to them

frequently and use them to instruct others who

may use this tool. If you loan someone this tool,

loan them these instructions also.

WARNING:

Some dust created by power sanding, sawing,

grinding, drilling, and other construction activities

contains chemicals known to cause cancer, birth

defects or other reproductive harm. Some ex-

amples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and

other masonry products, and

• arsenic and chromium from chemically-treated

lumber.

Your risk from these exposures varies, depending

on how often you do this type of work. To reduce

your exposure to these chemicals: work in a well

ventilated area, and work with approved safety

equipment, such as those dust masks that are

specially designed to filter out microscopic

particles.

RULES FOR SAFE OPERATION

The operation of any power tool can result in foreign objects being thrown into your

eyes, which can result in severe eye damage. Before beginning power tool operation,

always wear safety goggles or safety glasses with side shields and a full face shield

when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or

standard safety glasses with side shields. Always use eye protection which is marked

to comply with ANSI Z87.1.

WARNING:

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi MS181 Manuel de l'opérateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi MS181