Ryobi TS1300 Manuel de l'opérateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Page 12
0
30
45
15
15
Fig. 7
Fig. 8
Fig. 9
WARNING:
To prevent accidental starting that could cause possible
serious personal injury, assemble all parts, make sure all
adjustments are complete, and make sure all fasteners
are secure before connecting saw to power supply. Saw
should never be connected to power supply when you are
assembling parts, making adjustments, installing or re-
moving blades, or when not in use.
As mentioned previously your saw has been factory as-
sembled and adjusted. The miter lock handle, work clamp,
dust guide or dust bag, table extensions, stop block, and
blade are the only parts that have to be installed.
MITER LOCK HANDLE
See Figure 7.
To install the miter lock handle, place the threaded stud on
the end of the miter lock handle into the threaded hole in
the control arm under miter table. Turn clockwise to tighten.
WORK CLAMP (Optional)
See Figure 8.
To install optional work clamp, part number 982021-001,
place the shaft of the clamp in either hole in front of the
miter table base. Thread the 8 mm work clamp screw
provided into the side of the base and tighten it to secure
the clamp in position. Rotate the knob on the clamp to
move it in or out as needed.
WARNING:
When using the work clamp with the stop block, install the
clamp on the stop block side of the blade. This will
eliminate the possibility of the saw catching the loose end
and kicking up. Failure to heed this warning can result in
serious personal injury.
DUST GUIDE
See Figure 9.
To install the dust guide, place the end marked INSERT
over the exhaust port in the upper blade guard. Turn the
guide so that the open end is facing down.
TO INSTALL BLADE
See Figures 10, 11, and 12.
WARNING:
A 10 in. (254 mm) blade is the maximum blade capacity
of your saw. Never use a blade that is too thick to allow
outer blade washer to engage with the flats on the spindle.
Larger blades will come in contact with the blade guards,
while thicker blades will prevent the blade bolt from
securing the blade on the spindle. Either of these situa-
tions could result in a serious accident and can cause
serious personal injury.
TO
TIGHTEN
MITER
TABLE
CONTROL
ARM
TO
LOOSEN
MITER
LOCK HANDLE
MITER
TABLE BASE
8 mm WORK
CLAMP SCREW
WORK CLAMP
DUST GUIDE
UPPER
BLADE GUARD
EXHAUST
PORT
ASSEMBLY
45
15
0
30
15
0
0
30
45
15
15
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Commentaires sur ces manuels

Pas de commentaire