Ryobi TS1300 Manuel de l'opérateur télécharger pdf (Page 22)

Page 22

WARNING:

To ensure safety and reliability, all repairs — with the

exception of the externally accessible brushes — should

be performed by a qualified service technician at a Ryobi

Authorized Service Center to avoid risk of personal

injury.

BRUSH REPLACEMENT

See Figure 27.

Your saw has externally accessible brush assemblies that

should be periodically checked for wear.

Proceed as follows when replacement is required:

■ Unplug your saw.

WARNING:

Failure to unplug your saw could result in accidental

starting causing serious injury.

■ Remove brush cap with a screwdriver. Brush assembly

is spring loaded and will pop out when you remove

brush cap.

■ Remove brush assembly.

■ Check for wear. Replace both brushes when either has

less than 1/4 in. length of carbon remaining. Do not

replace one side without replacing the other.

■ Reassemble using new brush assemblies. Make sure

curvature of brush matches curvature of motor and that

brush moves freely in brush tube.

■ Make sure brush cap is oriented correctly (straight) and

replace.

■ Tighten brush cap securely. Do not overtighten.

MAINTENANCE

BRUSH

ASSEMBLY

Fig. 27

BRUSH

ASSEMBLY

BRUSH

CAP

BRUSH

CAP

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Ryobi TS1300 Manuel de l'opérateur Page 22