Ryobi TS1300 Manuel de l'opérateur télécharger pdf (Page 8)

Page 8

Fig. 1

Your Miter Saw has been shipped completely assembled

except for the blade, miter lock handle, dust guide or dust

bag, work clamp, table extensions, and stop block.

■ Remove all loose parts from the carton. Separate and

check with the list of Loose Parts.

See Figure 1.

■ Remove the packing materials from around your saw.

■ Carefully lift saw from the carton and place it on a level

work surface. Although small, this saw is heavy. To avoid

back injury, get help when needed.

■ Do not discard the packing materials until you have

carefully inspected the saw, identified all loose parts, and

satisfactorily operated your new saw.

■ Your saw has been shipped with the saw arm locked in

the down position. To release saw arm, push down on top

of saw arm and pull out the lock pin.

See Figure 3.

■ Lift the saw arm by the handle. Hand pressure should

remain on the saw arm to prevent sudden rise upon

release of the lock pin.

■ Examine all parts to make sure no breakage or damage

has occurred during shipping.

If any parts are damaged or missing, do not attempt to plug

in the power cord and turn the switch on until the damaged

or missing parts are obtained and are installed correctly.

Contact your nearest Ryobi dealer or call 1-800-525-2579 in

the United States or 1-800-265-6778 in Canada for assistance

if any parts are missing or damaged.

WARNING:

If any parts are missing do not operate your saw until the

missing parts are replaced. Failure to do so could result

in possible serious injury.

LOOSE PARTS LIST

The following items are included with your Miter Saw:

■ 10 in. (254 mm) Carbide Tipped Blade

■ Miter Lock Handle

■ Dust Guide

■ Blade Wrench

■ 5 mm Hex Key

■ 6 mm Hex Key

■ 8 mm Hex Key

■ Operator's Manual

■ Warranty Registration

Some models may include one or more of the following

accessories:

■ Work Clamp

■ 8 mm Work Clamp Screw

■ Dust Bag

■ Stop Block

■ Table Extensions (2)

■ Small Wing Screw (for use with stop block)

■ Large Wing Screws (2), for use with table extensions)

5 mm HEX KEY

8 mm HEX KEY

WORK CLAMP

SAW BLADE

MITER

LOCK HANDLE

BLADE WRENCH

8 mm WORK

CLAMP SCREW

UNPACKING AND CHECKING CONTENTS

SMALL WING

SCREW

STOP BLOCK

LARGE WING

SCREWS

DUST GUIDE

TABLE EXTENSIONS

DUST BAG

6 mm HEX KEY

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1300 Manuel de l'opérateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi TS1300