Ryobi TS1344L Manuel de l'opérateur télécharger pdf (Page 23)

OPERATION

 Grasp the stock firmly with one hand and secure it against

the fence. Use the optional work clamp or a C-clamp to

secure the workpiece when possible.

 Before turning on the saw, perform a dry run of the cutting

operation just to make sure that no problems will occur

when the cut is made.

 Grasp the saw handle firmly then squeeze the switch

trigger. Allow several seconds for the blade to reach

maximum speed.

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger and allow the saw blade to stop

rotating before raising the blade out of workpiece. Wait

until the electric brake stops blade from turning before

removing the workpiece from miter table.

TO SUPPORT LONG WORKPIECES

See Figure 28.

Long workpieces need extra supports. Supports should be

placed along the workpiece so it does not sag. The support

should let the workpiece lay flat on the base of the saw and

work table during the cutting operation. Use the optional

work clamp or a C-clamp to secure the workpiece.

45° X 45° COMPOUND MITER CUT

LONG WORKPIECE

WORKPIECE SUPPORTS

Fig. 27

Fig. 28

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Ryobi TS1344L Manuel de l'opérateur Page 23