Ryobi TS230 Manuel de l'opérateur Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
Page 18
Fig. 25
PIVOT ADJUSTMENTS
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
TRAVEL PIVOT ADJUSTMENT
The saw arm should rise completely to the up position
by itself.
If the saw arm does not raise by itself or if there is play
in the pivot joints, have saw repaired at your nearest
RYOBI FACTORY or AUTHORIZED SERVICE CEN-
TER.
BEVEL PIVOT ADJUSTMENT
Your compound miter saw should bevel easily by loos-
ening the bevel lock knob and tilting the saw arm to the
left.
If movement is tight or if there is play in the pivot, have
saw repaired at your nearest RYOBI FACTORY or
AUTHORIZED SERVICE CENTER.
DEPTH STOP
The depth stop limits the blade's downward travel. It
allows the blade to go below the miter table enough to
maintain full cutting capacities. The depth stop positions
the blade 1/4 in. (6.4 mm) from the miter table support.
NOTE: The miter table support is located inside miter table.
The depth stop is factory set to provide maximum cutting
capacity for the 10 in. (254 mm) saw blade provided with
your saw. Therefore, the saw blade provided should never
need adjustments.
However, when the diameter of the blade has been reduced
due to sharpening, it may be necessary to adjust the depth
stop to provide maximum cutting capacity. Also, when a new
blade is installed, it is necessary to check the clearance of
the blade to the miter table support.
DEPTH STOP ADJUSTMENTS
See Figure 25.
Unplug your saw.
WARNING:
Failure to unplug your saw could result in accidental
starting causing possible serious personal injury.
To adjust the depth stop use a 17 mm wrench or
adjustable wrench and loosen the hex nut at the rear of
the miter saw arm.
Use the 5 mm hex key (allen wrench) provided to adjust
the depth stop adjustment screw. The saw blade is
lowered by turning the screw counterclockwise and
raised by turning the screw clockwise.
Lower the blade into the zero clearance throat plate of
the miter table. Check blade clearance and maximum
cutting distance (distance from fence where blade enters)
to front of miter table slot.
Readjust if necessary.
WARNING:
Do not start your compound miter saw without checking
for interference between the blade and the miter table
support. Damage could result to the blade if it strikes the
miter table support during operation of the saw.
Tighten the hex nut with a 17 mm wrench or adjustable
wrench.
To prevent the depth stop adjustment screw from turning
while tightening the hex nut, carefully hold it with the hex
key (allen wrench) while tightening the hex nut.
ADJUSTMENTS
APPLICATIONS
(Use only for the purposes listed below)
Cross cutting wood and plastic.
Cross cutting miters, joints, etc. for picture frames,
moldings, door casings, and fine joinery.
NOTE: The 30 tooth crosscut blade provided is fine for most
wood cutting operations, but for fine joinery cuts or cutting
plastic, use one of the accessory blades available from your
Ryobi dealer.
OPERATION
HEX
NUT
BEVEL
LOCK KNOB
DEPTH STOP
ADJUSTMENT
SCREW
POSITIVE
STOP ADJUSTMENT
SCREW FOR 0
° ANGLES
MITER
TABLE
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Commentaires sur ces manuels

Pas de commentaire