Ryobi TS230 Manuel de l'opérateur télécharger pdf (Page 24)

Page 24

10°

0°

Fig. 31

Fig. 32

Fig. 33

RIGHT

CUTTING WARPED MATERIAL

See Figures 31 and 32.

When cutting warped material, always make sure it is

positioned on the miter table with the convex side against the

fence as shown in figure 31.

If the warped material is positioned the wrong way, it will

pinch the blade near the completion of the cut as shown in

figure 33.

WARNING:

To avoid a kickback and to avoid serious personal injury,

never position the concave edge of bowed/warped material

against the fence.

ALTERNATE METHOD OF CLAMPING

WORKPIECE

See Figure 33.

When cutting workpieces that are too wide to be clamped

with the work clamp provided, a C-clamp must be used. For

example when cutting 2 in. x 6 in. boards.

OPERATION

WIDE

BOARD

C-CLAMP

WRONG

1 2 ... 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Ryobi TS230 Manuel de l'opérateur Page 24