Ryobi TS230 Manuel de l'opérateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
Page 8
R
O
T
A
T
I
O
N
R
O
T
A
T
I
O
N
I
N
S
Fig. 1
Your Model TS230 Compound Miter Saw has been shipped
completely assembled except for the blade, miter lock handle,
work clamp, and dust guide.
Remove all loose parts from the carton. Separate and
check with the list of Loose Parts.
See Figure 1.
Remove the packing materials from around your saw.
Carefully lift saw from the carton and place it on a level
work surface. Although small, this saw is heavy. To
avoid back injury, get help when needed.
Do not discard the packing materials until you have
carefully inspected the saw, identified all loose parts,
and satisfactorily operated your new saw.
Your saw has been shipped with the saw arm locked in
the down position. To release saw arm, push down on
top of saw arm and pull out the lock pin.
See Figure 3.
Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the lock pin.
Examine all parts to make sure no breakage or damage
has occurred during shipping.
If any parts are damaged or missing, do not attempt to plug
in the power cord and turn the switch on until the damaged
or missing parts are obtained and are installed correctly.
Contact your nearest Ryobi dealer or call 1-800-525-2579 in
the United States or 1-800-265-6778 in Canada for assistance
if any parts are missing or damaged.
UNPACKING AND CHECKING CONTENTS
WARNING:
If any parts are missing do not operate your saw until the
missing parts are replaced. Failure to do so could result
in possible serious injury.
LOOSE PARTS LIST
The following items are included with your TS230 Compound
Miter Saw:
Saw Blade - 10 in. (254 mm), 30 Tooth Carbide Tipped
Crosscut Saw Blade
Miter Lock Handle
Work Clamp
8 mm Work Clamp Screw
Dust Guide
Blade Wrench
5 mm Hex Key (allen wrench)
8 mm Hex Key (allen wrench)
Operator's Manual
Warranty Registration
5 mm HEX KEY
(ALLEN WRENCH)
8 mm HEX KEY
(ALLEN WRENCH)
WORK CLAMP
SAW BLADE
DUST GUIDE
MITER LOCK HANDLE
BLADE WRENCH
8 mm WORK CLAMP SCREW
Fig. 1
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire