Ryobi YG125CS Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

9 — English

OPERATION

WARNING:

During normal use the tool will recoil immediately

after driving a fastener. This is a normal function of

the tool. Do not attempt to prevent the recoil by holding

the stapler against the work. Restriction to the recoil can

result in a second fastener being driven from the stapleer.

Grip the handle firmly, let the tool do the work, and do

not place second hand on top of tool or near exhaust at

any time. Failure to heed this warning can result in seri-

ous personal injury.

SETTING THE AIR PRESSURE

The amount of air pressure required will depend on the size

of the staple and the workpiece material.

Begin testing the depth of drive by driving a test staple into

the same type of workpiece material used for the actual job.

Drive a test staple with the air pressure set at 90-95 psi.

Raise or lower the air pressure to find the lowest setting that

will perform the job with consistent results.

It may be possible to achieve the desired depth with air

pressure adjustments alone. If finer adjustments are needed,

use the drive depth adjustment on the tool.

DEPTH OF DRIVE ADJUSTMENT

See Figure 7, page 14.

The driving depth of the staple may be adjusted. It is advis-

able to test the depth on a scrap workpiece to determine

the required depth for the application.

To determine depth of drive, first adjust the air pressure and

drive a test staple. To achieve the desired depth, use the

drive depth adjustment on the tool.

Disconnect the tool from the air supply.

Turn the depth selector left or right to change the driving

depth.

Reconnect the tool to the air supply.

Drive a test staple after each adjustment until the desired

depth is set.

WARNING:

Disconnect the tool from the air supply before removing

staples. Failure to do so could result in serious personal

injury.

REMOVING STAPLES FROM THE TOOL

See Figure 8, page 14.

Disconnect the tool from the air supply.

To remove a strip of staples from the tool, depress the

latch located at the rear of the magazine and slide the

magazine open.

Remove the strip of staples.

To close the magazine, push it forward until the latch

clicks into place

WARNING:

Disconnect the tool from the air supply before clearing a

jammed fastener. Failure to do so could result in serious

personal injury.

CLEARING A JAMMED FASTENER

See Figures 9 - 11, page 14.

If a staple or fastener becomes jammed in the tool, discon-

nect the air hose and keep the tool pointed away from you

while clearing the jam.

Disconnect the tool from the air supply.

Remove fasteners from the tool.

Pull up on the latch and open the jam release.

Insert a flat blade screwdriver into the driving mechanism

and push the mechanism back, freeing the fastener jam.

Remove the bent fastener.

Close the jam release and latch.

Reconnect the tool to the air supply.

Reinstall fasteners.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi YG125CS Manuel d'utilisation et d'entretien Page 9

Commentaires sur ces manuels