Ryobi YG250FS Manuel d'utilisation et d'entretien télécharger pdf (Page 11)

11 — English

MAINTENANCE

REQUIRED DAILY CHECKLIST

Disconnect the air supply from the tool and remove all

fasteners.

Check all screws, nuts, bolts, and pins on the tool. If

any of these are loose, they must be tightened with the

appropriate size wrench.

Press the workpiece contact against a workpiece to

ensure that it moves smoothly.

With the workpiece contact depressed, pull the trigger.

The trigger should move smoothly, without binding.

While the tool is not loaded, connect the appropriate air

supply (at 70 psi) to the tool.

 Without pulling the trigger, press the workpiece contact

against a workpiece several times. The tool must not

operate. No air should leak from the tool.

With the workpiece contact not engaged on the

workpiece, point the tool down and away and pull the

trigger several times. Hold the trigger in this position for

a minimum of 5 seconds. The tool must not operate.

Press the workpiece contact firmly against the workpiece.

Pull the trigger. The tool must operate.

With the workpiece contact still depressed, release the

trigger. The driver must return to its up position.

If the tool successfully meets all the requirements in this

checklist, it is ready for use. Load the proper fasteners

for the desired application.

Set the depth of drive according to the Drive of Depth

Adjustment section in this manual. Repeat this checklist

before using the tool each day, or if the tool is dropped

or damaged in any way.

ACCESSORIES

WARNING:

Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or

accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended

can result in serious personal injury.

To order parts and maintenance kits, call 1-800-525-2579.

Overhaul Maintenance Kit ................................................................................................................................079077005701

Driver Maintenance Kit .....................................................................................................................................079077005702

Driver Assembly Kit ..........................................................................................................................................079077005703

Trigger Valve Assembly Kit ...............................................................................................................................079077005704

Oil and Wrench Kit............................................................................................................................................079077005705

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Commentaires sur ces manuels

[email protected] 22 Jan 2024 | 07:34:05

Plunger won't return

Ryobi YG250FS Manuel d'utilisation et d'entretien Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Pistolet à clous Ryobi YG250FS