Ryobi YG250FS Manuel d'utilisation et d'entretien télécharger pdf (Page 12)

12 — English

TROUBLESHOOTING

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 14 AFTER

FRENCH AND SPANISH LANGUAGE SECTIONS.

PROBLEM POSSIBLE CAUSE SOLUTION

Air leak near the top of the tool or in the

trigger area

Loose screws

Worn or damaged O-rings or seals

Tighten screws

Install Overhaul Kit

Air leak near the bottom of the tool Worn or damaged O-rings or bumper Install Overhaul Kit

Tool does nothing or operates sluggishly Inadequate air supply

Worn or damaged O-rings or bumper

Verify adequate air supply

Install Overhaul Kit

Tool jams frequently Incorrect fasteners

Damaged fasteners

Loose magazine

Dirty magazine

Worn or damaged driver

Verify that fasteners are the correct size

Replace fasteners

Tighten screws

Clean magazine

Install Driver Maintenance Kit

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

[email protected] 22 Jan 2024 | 07:34:05

Plunger won't return

Ryobi YG250FS Manuel d'utilisation et d'entretien Page 12