Ryobi YG250FS Manuel d'utilisation et d'entretien télécharger pdf (Page 4)

4 — English

SPECIFIC SAFETY RULES

During normal use the tool will recoil immediately

after driving a fastener. This is a normal function of

the tool. Do not attempt to prevent the recoil by holding

the nailer against the work. Restriction to the recoil can

result in a second fastener being driven from the nailer.

Grip the handle firmly and let the tool do the work. Failure

to heed this warning can result in serious personal injury.

Do not drive fasteners on top of other fasteners or with

the tool at an overly steep angle as this may cause

deflection of fasteners which could cause injury.

Do not drive fasteners close to the edge of the

workpiece as the wood may split, allowing the fastener

to be deflected possibly causing injury.

AIR SUPPLY AND CONNECTIONS

Do not use oxygen, combustible gases or bottled gases

as a power source for this tool as tool will explode,

possibly causing injury or death.

Do not use with an air compressor which can potentially

exceed 200 psi, as tool may burst, possibly causing

injury.

The connector on the tool must not hold pressure when

air supply is disconnected. If an incorrect fitting is used,

the tool can remain charged with air after disconnecting

and thus will be able to drive a fastener even after the air

line is disconnected, possibly causing injury.

Always disconnect air supply:

• Before making adjustments

• When servicing the tool

• When clearing a jam

• When tool is not in use

• When moving to a different work area, as accidental

actuation may occur, possibly causing injury.

LOADING TOOL

Do not load the tool with fasteners when any one of

the operating controls is activated.

When loading tool:

Never place a hand or any part of body in fastener

discharge area of tool.

Never point tool at anyone.

Do not pull the trigger or depress the workpiece

contact as accidental actuation may occur, possibly

causing injury.

SAVE THESE INSTRUCTIONS

Refer to them frequently and use them to instruct others

who may use this tool. If you loan someone this tool, loan

them these instructions also.

1 2 3 4 5 6 7 8 9 ... 39 40

Commentaires sur ces manuels

[email protected] 22 Jan 2024 | 07:34:05

Plunger won't return

Ryobi YG250FS Manuel d'utilisation et d'entretien Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Pistolet à clous Ryobi YG250FS