Ryobi YG250FS Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

9 — English

OPERATION

SETTING THE AIR PRESSURE

The amount of air pressure required will depend on the size

of the nail and the workpiece material.

Begin testing the depth of drive by driving a test nail into

the same type of workpiece material used for the actual job.

Drive a test nail with the air pressure set at 90-95 psi. Raise

or lower the air pressure to find the lowest setting that will

perform the job with consistent results.

It may be possible to achieve the desired depth with air

pressure adjustments alone. If finer adjustments are needed,

use the drive depth adjustment on the tool.

DEPTH OF DRIVE ADJUSTMENT

See Figure 8, page 15.

The driving depth of the nail may be adjusted. It is advisable

to test the depth on a scrap workpiece to determine the

required depth for the application.

To determine depth of drive, first adjust the air pressure and

drive a test nail. To achieve the desired depth, use the drive

depth adjustment on the tool.

Disconnect the tool from the air supply.

Turn the depth selector left or right to change the driving

depth.

Reconnect the tool to the air supply.

Drive a test nail after each adjustment until the desired

depth is set.

WARNING:

Disconnect the tool from the air supply before removing

nails. Failure to do so could result in serious personal

injury.

REMOVING NAILS FROM THE TOOL

See Figure 9, page 15.

Disconnect the tool from the air supply.

Slide the pusher all the way to the rear of the magazine

until it locks into place.

NOTE: Always keep fingers clear of nail track of magazine

to prevent injury from unintended release of the pusher.

Tilt the tool as shown so that the nails slide out of the

magazine.

WARNING:

Disconnect the tool from the air supply before clearing a

jammed fastener. Failure to do so could result in serious

personal injury.

CLEARING A JAMMED FASTENER

See Figure 10, page 15.

If a nail or fastener becomes jammed in the tool, disconnect

the air hose and keep the tool pointed away from you while

clearing the jam.

Disconnect the tool from the air supply.

Remove fasteners from the tool.

Pull up on the latch and open the jam release.

Insert a flat blade screwdriver into the driving mechanism

and push the driver mechanism back, freeing the fastener

jam.

Remove the bent fastener.

Close the jam release and latch.

Reconnect the tool to the air supply.

Reinstall fasteners.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Commentaires sur ces manuels

[email protected] 22 Jan 2024 | 07:34:05

Plunger won't return

Ryobi YG250FS Manuel d'utilisation et d'entretien Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Pistolet à clous Ryobi YG250FS