Ryobi YN200BND Manuel de l'opérateur télécharger pdf (Page 10)

10 - English

OPERATION

WARNING:

Disconnect the tool from the air supply before leaving the

work area, moving the tool to another location, or handing

the tool to another person. Failure to do so could result

in serious personal injury.

CONNECTING THE TOOL TO AN AIR SUPPLY

See Figure 5, page 15.

DANGER:

Do not use oxygen, combustible gases or bottled gases

as a power source for this tool. The tool will explode and

cause death or serious injury.

This tool is designed to operate on clean, dry compressed air

at regulated pressures between 70 and 120 psi . The correct

air pressure is the lowest pressure that will do the job.

NOTE: Air pressure that is higher than 120 psi may damage

the tool.

The tool must have an air fitting that allows all pressure

to discharge from the tool when the air hose connector is

disconnected.

WARNING:

Always use an air fitting that discharges all the

compressed air in the tool at the time the air fitting and

air hose connector is disconnected. Using an air fitting

that does not discharge the compressed air could cause

unintended operation and serious personal injury.

WARNING:

Do not climb rigging or scaffolding while carrying a tool

that is connected to an air hose. Doing so could result in

serious personal injury.

Connect the tool to the air supply with a 1/4 in. female quick

connector.

LOADING THE TOOL WITH NAILS

See Figures 6 - 7, page 15 - 16.

Connect the tool to the air supply.

WARNING:

The tool’s driving mechanism may cycle when the tool

is first connected to the air supply. Always connect the

tool to the air supply before loading nails to prevent injury

from unintended cycling. Always make sure the tool’s

magazine is empty at the beginning of each work session,

before connecting to an air supply.

WARNING:

Keep the tool pointed away from yourself and others

when loading nails. Failure to do so could result in

possible serious personal injury.

WARNING:

Use only the nails recommended for use with this tool.

The use of any other nails can result in tool malfunction,

leading to serious injuries.

WARNING:

Never load nails with the workpiece contact or trigger

activated. Doing so could result in possible serious

personal injury.

Pushthelatchtoreleaseandopen the magazine.

With the nose of the tool pointed away from you, insert

a strip of nails into the magazine. Be sure the nails are

pointed downward.

CORRECT NAIL POSITION

Nails should always be inserted with the points down-

ward, fitting into the nail track, or as close as possible to

the nail track.

Nail heads must sit either on the top edge of a rib or inside

a track between two ribs.

Nail heads should never lie on top of a rib without sitting

on the rib edge. Do not position nail heads in the center

of a rib.

The strip of nails should not be centered in the magazine

or positioned at the top portion of the magazine.

If the nail points will not sit inside the track without sitting

incorrectly on a rib, move the nail strip up slightly until

the heads sit on the top edge of a rib.

To close the magazine, depress the latch and push the

magazine forward. Release the latch and make sure the

latch is securely locked into place before driving a nail.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi YN200BND Manuel de l'opérateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Pistolet à clous Ryobi YN200BND