Ryobi YN200BND Manuel de l'opérateur télécharger pdf (Page 7)

7 - English

GLOSSARY OF TERMS

Activate (operating controls)

To move an operating control so that it is in a position that

allows the tool to be actuated or that satisfies one requirement

for the tool to be actuated.

Actuate (tool)

To cause movement of the tool component(s) intended to

drive a fastener.

Air inlet port

In an air tool, the opening to which the compressed air supply

is connected, usually by means of a threaded fitting.

Fastener

A staple, pin, brad, nail, or other fastening device which is

designed and manufactured for use in the tools within the

scope of this standard.

Jam

An obstruction in the feed or drive areas of the tool.

Maximum air pressure

The maximum allowable pressure of the compressed air, as

specified by the manufacturer, for operating a tool.

Operating control

A control that separately, or as part of an actuation system,

can cause the actuation of a tool.

Single sequential actuation

An actuation system in which there is more than one operating

control and the operating controls must be activated in a

specific sequence to actuate the tool. Additional actuation

can occur when a specific operating control, other than a

workpiece contact, is released and re-activated.

Trigger

A tool operating control activated by a tool operator’s

fingers.

Workpiece

The intended object into which a fastener is to be driven

by a tool.

Workpiece contact

An operating control element or assembly on the tool intended

to be activated by the material to be fastened.

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Pas de commentaire

Ryobi YN200BND Manuel de l'opérateur Page 7