Ryobi YN200BND Manuel de l'opérateur télécharger pdf (Page 9)

9 - English

DANGER:

Do not use oxygen, combustible gases or bottled gases

as a power source for this tool. The tool will explode and

cause death or serious injury.

WARNING:

Do not allow familiarity with tools to make you careless.

Remember that a careless fraction of a second is

sufficient to inflict severe injury.

WARNING:

Always wear eye protection with side shields marked

to comply with ANSI Z87.1 along with hearing and

head protection. Failure to do so could result in objects

being thrown into your eyes and other possible serious

injuries.

WARNING:

Disconnect the tool from the air supply before leaving the

work area, moving the tool to another location, or handing

the tool to another person. Failure to do so could result

in serious personal injury.

APPLICATIONS

You may use this tool for the purposes listed below:

 Finish and Trim (interior and exterior)

 Decorative Trim

 Book Cases

 Baseboard

 Cabinets

 Case Backs

 Drawers

 Molding

 Mirror and Picture Frames

 Paneling

 Shoe & Base Moldings

 Staircases

 Upholstery Trim Panels

 Wainscoting

 Window Beading

 Chair Rail

 Furniture Frames

 Lattice Strip Molding

 Nailable Plastic Parts

 Crafts

OPERATION

WARNING:

Always wear eye protection. Eye protection does not fit all

operators in the same way. Make sure the eye protection

chosen has side shields or provides protection from flying

debris both from the front and sides.

PREPARING THE TOOL FOR USE

See Figure 2, page 15.

Under normal use conditions, the tool should be lubricated

before connecting the tool to an air supply. Add air tool oil

into the air fitting on the tool once daily with minimal use,

or twice a day with heavy use. Only a few drops of oil at a

time is necessary. Too much oil will only collect inside the

tool and will be noticeable in the exhaust cycle.

Before connecting the tool, check the air compressor

gauge to be sure it is functioning within the proper range of

70-120 psi.

NO-MAR NOSEPIECE

See Figure 3, page 15.

The no-mar nosepiece attached to the workpiece contact

of the tool helps prevent marring and denting when working

with softer woods.

WARNING:

Disconnect the tool from the air supply before removing

or replacing the no-mar nosepiece. Failure to do so could

result in serious personal injury.

The no-mar nosepiece can be removed by pulling it down

and away from the nose. To replace the no-mar nosepiece,

fit it into place over the workpiece contact and push up at

the back to reseat.

ADJUSTING THE EXHAUST

See Figure 4, page 15.

The adjustable exhaust on the end cap of the tool allows

the operator to direct the exhaust according to operator

preference. To adjust, turn the exhaust cap until the exhaust

blows in the desired direction.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi YN200BND Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Pistolet à clous Ryobi YN200BND