Ryobi YN250SFD Manuel de l'opérateur télécharger pdf (Page 10)

10 — English

WARNING:

Always use an air fitting that discharges all the com-

pressed air in the tool at the time the air fitting and air

hose connector is disconnected. Using an air fitting that

does not discharge the compressed air could cause un-

intended operation and serious personal injury.

WARNING:

Do not climb rigging or scaffolding while carrying a tool

that is connected to an air hose. Doing so could result in

serious personal injury.

Connect the tool to the air supply with a 1/4 in. female quick

connector.

LOADING THE TOOL WITH NAILS

See Figures 6 - 7, page 16.

Connect the tool to the air supply.

WARNING:

The tool’s driving mechanism may cycle when the tool

is first connected to the air supply. Always connect the

tool to the air supply before loading nails to prevent injury

from unintended cycling. Always make sure the tool’s

magazine is empty at the beginning of each work ses-

sion, before connecting to an air supply.

WARNING:

Keep the tool pointed away from yourself and others

when loading nails. Failure to do so could result in pos-

sible serious personal injury.

WARNING:

Use only the nails recommended for use with this tool.

The use of any other nails can result in tool malfunction,

leading to serious injuries.

WARNING:

Never load nails with the workpiece contact or trigger

activated. Doing so could result in possible serious per-

sonal injury.

Slide the pusher all the way to the rear of the magazine

until it locks into place.

With the nose of the tool pointed away from you, feed

a strip of nails into the magazine. Be sure the nails are

pointed downward as shown.

Depress the pusher release located on the top of the

magazine to allow the pusher to move the nails up to the

driving mechanism. The pusher will stop when it rests

against the end of the nail strip.

DRIVING A FASTENER

See Figure 8, page 16.

WARNING:

Never wedge or hold back the workpiece contact mecha-

nism during operation of the tool. Doing so could result

in possible serious injury.

SINGLE SEQUENTIAL ACTUATION

Single sequential actuation provides accurate fastener

placement.

Connect the tool to the air supply.

Grip the tool firmly to maintain control. Position the nose

of the tool onto the work surface.

Push the tool against the work surface to depress the

workpiece contact.

Pull the trigger to drive a fastener.

Allow the tool to recoil away from the work surface as the

fastener is driven.

WARNING:

During normal use the tool will recoil immediately

after driving a fastener. This is a normal function of

the tool. Do not attempt to prevent the recoil by holding

the nailer against the work. Restriction to the recoil can

result in a second fastener being driven from the nailer.

Grip the handle firmly, let the tool do the work, and do

not place second hand on top of tool or near exhaust at

any time. Failure to heed this warning can result in seri-

ous personal injury.

OPERATION

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi YN250SFD Manuel de l'opérateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Pistolet à clous Ryobi YN250SFD