Ryobi r163 Manuel de l'opérateur télécharger pdf (Page 13)

NOTE: To adjust the depth of cut when the router is

mounted to a router table, unplug the router, loosen the lock

lever, turn the depth adjustment knob until the bit reaches the

desired depth of cut, and retighten the lock lever.

When the router is mounted to a router table, depth adjust-

ments can be made easily by using a T-handle wrench.

To make through table adjustments:

 Unplug the router.

 Loosen the lock lever.

 Insert a T-handle wrench through the hole in the router

table into the hole on the subbase, and place the end of

the wrench socket over the adjusting nut.

 Turn the wrench counterclockwise to move the collet

down or clockwise to move the collet up.

NOTE: It should not be possible to make depth

adjustments with the lock lever tightened. If depth

adjustments are possible with the lock lever tightened,

an adjustment to the lock lever needs to be made. See

Adjustments.

 When the desired depth of cut is set, tighten the

lock lever.

WARNING:

Do not use with router tables that fail to conform to safe

woodworking practices and offer proper guarding for the

bit. Use router tables that are UL classified and identified

suitable for use with the specific router model. Failure

to comply can result in an accident causing possible

injury.

WARNING:

Only use router tables with proper guarding for the bit and

with on-board switch controlled receptacles. Failure to

use router tables with appropriate safety features could

result in serious personal injury.

TURNING THE ROUTER ON AND OFF

See Figure 7.

To turn the router on, push the switch to the ( I ), or ON

position. Return the switch to the ( O ), or OFF position when

routing operation is finished.

OPERATION

Fig. 7

ON/OFF

SWITCH

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Ryobi r163 Manuel de l'opérateur Page 13