Ryobi R180 Manuel de l'opérateur télécharger pdf (Page 8)

Page 8

Fig. 9

Fig. 10

ROUTER MOUNTING

4–HOLE ROUTER WITH MOUNTING PLATE ATTACHED

ROUTER

MOUNTING

SCREWS

FRONT

OF ROUTER

ROUTER

MOUNTING

PLATE

ROUTER WITH 4–HOLE PATTERN

TO ASSEMBLE ROUTERS WITH 4-HOLE

PATTERN TO ROUTER MOUNTING PLATE:

See Figures 9 and 10.

Note: For Ryobi routers, model numbers RE600 and

RE601.

■ Unplug the router.

WARNING: Unplug the router to avoid

possible injury.

■ Make sure the router switch is OFF and the router is

not connected to a power source.

■ Place the router upside down on a workbench and

remove the subbase screws and subbase from the

router.

■ Align mounting holes of the mounting plate with the

four threaded holes in the router base.

■ The switch handle of the router should be facing the

squared end of the mounting plate.

See Figure 9.

■ Secure the router mounting plate to the router using

four M8 flat head screws provided in the router

mounting kit.

■ Properly installed, the mounting plate will be securely

attached to the router.

See Figure 10.

■ Tighten screws securely.

TO ASSEMBLE MOUNTING PLATE WITH

ROUTER ATTACHED TO ACCESSORY TABLE:

■ Place the router and the mounting plate under the

accessory table.

See Figure 11.

■ Secure the mounting plate to accessory table using

the four #1/4-20 x 1/2 in. flat head screws provided.

Note: The accessory table can be removed from the

table saw to attach the router and mounting plate.

Follow instructions in the table saw operator's manual

for removing and reattaching the accessory table.

■ Tighten screws securely.

ROUTER

BASE

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Ryobi R180 Manuel de l'opérateur Page 8

Commentaires sur ces manuels