Ryobi RT401W Manuel de l'opérateur télécharger pdf (Page 17)

OPERATION

WARNING:

Feed workpiece against the router bit's direction of

rotation. Unplug router prior to changing the bit,

modifying settings, or making any other adjustments.

Using the router for beading

and edge cutting

See Figure 18 and 19

1. Loosen the knobs that hold the fences in place.

See number 2 in figure 18 below.

Fig. 18

2. Position the right fence for the desired cutting depth.

See number 3 in figure 19 below.

1. Tabletop

2. Right fence

3. Cutting depth

4. Workpiece

5. Successive cut

6. Depth of cut

7. Router bit

2 21 3

1. Left fence

2. Knobs

3. Right fence

4. Straightedge

Fig. 19

3. Tighten the knobs that secure the right fence in place.

4. Place a straightedge against the right fence face.

NOTE: When making this adjustment, the router bit can

interfere with the straightedge. If this occurs, lower the

bit below the surface of the table until both fences are

positioned.

5. Using the straightedge as a guide, position the left

fence so it is even with the right fence.

6. Swing the safety shield over the router bit.

7. Your router/router table is now ready to use.

NOTE: Test on a scrap of wood before making final cuts.

Using the router as a jointer

See Figure 20

NOTE: Make sure boards that are to be jointed together

are true and smooth. Also make sure edges are prepared

properly.

1. Loosen the knobs holding the fences in place.

2. Against the left fence, place a straightedge.

3. Slide fence until straightedge touches the outside

diameter of the router bit.

4. Tighten the left fence knobs.

Fig. 20

2 21 3

6 4

1. Left fence

2. Knobs

3. Right fence

4. Depth of cut

5. Router bit

6. Straightedge

Bdal 6144.461 3Sprachen 04.06.2005 11:56 Uhr Seite 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi RT401W Manuel de l'opérateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Ryobi RT401W