Ryobi RT501W Spécifications télécharger pdf (Page 15)

Fig. 13

MOUNTING THE ROUTER

See Figure 13

6. Mount the router with adaptor base plate by putting the

pan head screws (AG) through the holes in the tabletop

and fasten to the nuts in the adapter plate (F) at posi-

tion H. (The adapter plate comes from the factory with

the mounting nuts pressed into it.) Tighten securely.

CAUTION:

Make sure the screws from router base plate are

long enough to mount router securely. Replace if

necessary.

AG (3)

II. Mounting Routers with Three-Hole

Base Plate (Hole Pattern "E")

Note: Refer to Hole Pattern Chart on page 14 to deter-

mine the correct hole pattern for your router.

See Figure 14

1. Remove router base plate from router by removing

screws.

2. While holding router upside down, position it to the

underside within the center ring of the table top.

3. Rotate router until the three mounting holes in router

base line up with the three larger holes in the table top.

4. Insert three machine screws from router base plate

through holes in tabletop and into router mounting

holes. Tighten securely.

5. To mount Craftsman routers that use the E-hole

pattern to the table top, use three 10 - 32 x 1/2" pan

head screws (not provided).

NOTE: For ease of use, position the router so the

ON-OFF switch is accessible from the front of the

table.

CAUTION:

Make sure the screws from router base plate are

long enough to mount router securely. Replace if

necessary.

Fig. 14

NOTE: Screw from

router base plate or

10-32 X 1/2" pan

head screw.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Ryobi RT501W Spécifications Page 15