Ryobi RT501W Spécifications télécharger pdf (Page 21)

Fig. 26

Using fence

See Figure 26

To position the fence on tabletop, make this adjustment.

1. Place the fence on the tabletop.

2. Loosen the 2 knobs (T).

3. Slide the fence into the required position.

NOTE: Fence should always be parallel with the frontside

of the table.

4. Tighten the knobs (T) by turning clockwise.

CAUTION:

Make sure that the 4 knobs (connected to the

2 adjustable fences) are securely tightened.

Fence

Adustable

fence

OPERATION

Using your router/router table

WARNING:

Before you start work with your new router table: Refer

to your router owner's manual to see how the height of

the cut can be adjusted.

WARNING:

Make sure router is unplugged before starting

depth/height adjustments.

NOTE: Using scrap board that is smooth and true is

recommended for making this adjustment.

See Figure 27

1. At the end of the board, use a soft pencil to mark line

#1. This indicates the depth of the cut.

2. Then mark line #2, indicating the height of the cut.

3. Place your board so that it is snug against the fence

face. The end with lines #1 and #2 should be near the

bit.

4. Loosen fence clamping knobs enough so you can move

the fence easily. Move fence and board so that the

board contacts the outer edge of the router bit at line

#1.

5. Tighten fence clamping knobs.

6. Adjust router height so the cutting edge of the bit

contacts line #2.

7. Make sure bit is securely tightened in the collet.

Fig. 27

Pencil line #1 Pencil line #2

Adustable

fence

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi RT501W Spécifications Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Ryobi RT501W