Ryobi P542 Manuel d'utilisateur télécharger pdf (Page 11)

11 - English

OPERATION

CAUTION:

Remove battery pack from unit. Fill oil tank with

Ryobi Bar and Chain Lubricant before starting

the chain saw. Failure to lubricate the chain will

cause damage to the bar and chain.

CHAIN OIL SYSTEM

See Figure 6.

 Use Ryobi Bar and Chain Lubricant. It is formu-

lated to perform over a wide temperature range

with no dilution required.

NOTE: Do not use dirty, used or otherwise contam-

inated oils. Damage may occur to the bar or chain.

 Carefully pour the bar and chain oil into the tank.

 Check and fill the oil tank when battery is

recharged, or as needed.

 Depress the oil tank cap several times to pump

the oil to the chain before starting the saw.

 Depress the oil tank cap every 20-30 seconds

while cutting to keep the chain lubricated.

NOTE: It is normal for lubricant to seep from the

saw when not in use. To prevent seepage, empty

the oil tank after each use. When storing the unit

for a long period of time (three months or longer) be

sure the chain is lightly lubricated; this will prevent

rust on the chain and bar sprocket.

APPLICATIONS

You may use this product for the following pur-

poses:

Limbing and pruning branches from trees

Felling small trees up to 7 in. diameter

Bucking the fallen tree into shorter lengths

This product will accept Ryobi One+ 18 V lithium-

ion battery packs and Ryobi One+ 18 V nickel-

cadmium battery packs.

For complete charging instructions, refer to the

Operator’s Manual for your Ryobi One+ battery

pack and charger models.

TO INSTALL / REMOVE BATTERY PACK

See Figure 5.

WARNING:

Always remove battery pack from your tool

when you are assembling parts, making adjust-

ments, cleaning, carrying, transporting or when

not in use. Removing battery pack will prevent

accidental starting that could cause serious

personal injury.

NOTE: To avoid serious personal injury, always

remove the battery pack and keep hands clear of

the look-out button when carrying or transporting

the tool.

To install:

 Place the battery pack in your chain saw. Align

raised rib on battery pack with groove in chain

saw’s battery port.

 Make sure the latches on each side of the bat-

tery pack snap in place and that battery pack is

secured in chain saw before beginning operation.

To remove:

Locate latches on side of battery pack and depress

both sides to release the battery pack from the

chain saw.

CAUTION:

When placing battery pack in your chain saw,

be sure raised rib on battery pack aligns with

groove in chain saw’s battery port and latches

snap in place properly. Improper assembly of

battery pack can cause damage to internal

components.

Fig. 6

Fig. 5

BATTERY

PACK

LATCHES

BATTERY

PORT

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

Commentaires sur ces manuels

Pas de commentaire

Ryobi P542 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outil à essence Ryobi P542