Ryobi RY43006 Manuel d'utilisateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 30
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
13
OPERATION
AUTOMATIC CHAIN OIL SYSTEM
See Figure 6.
NOTE: Chain saw comes from the factory with no bar
and chain oil added.
n Use Power Care Bar and Chain Oil. It is formulated to
perform over a wide temperature range with no dilution
required.
n Remove oil cap.
n Carefully pour the bar and chain oil into the tank.
n Wipe off excess oil.
n Check and fill the oil tank when quick view oil indicator
is below the second to last indicator line.
n Repeat as needed.
NOTE: Do not use dirty, used or otherwise contaminated
oils. Damage may occur to the bar or chain.
NOTE: It is normal for oil to seep from the saw when not in
use. To prevent seepage, empty the oil tank after each use
then run for one minute. When storing the unit for a long
period of time (three months or longer) be sure the chain
is lightly lubricated; this will prevent rust on the chain and
bar sprocket.
CONNECTING TO POWER SUPPLY
See Figure 7.
This chain saw is designed with an extension cord hitch
that prevents the extension cord from being pulled loose
while using.
n Form a loop with the end of the extension cord.
n Insert loop portion of extension cord through the opening
in the side of the rear handle and place over cord hitch.
n Slowly pull loop against cord hitch until the slack is re-
moved.
n Plug extension cord into rear handle of chain saw.
NOTE: Failure to remove all excess cord slack from
extension cord hitch could result in plug loosening from
receptacle.
Fig. 6
Fig. 7
OIL RESERVOIR
CAP
QUICK VIEW
OIL INDICATOR
EXTENSION
CORD
EXTENSION
CORD HITCH
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Commentaires sur ces manuels

Pas de commentaire