Ryobi RY43006 Manuel d'utilisateur télécharger pdf (Page 27)

SAFE-T-TIP

NOSE GUARD MAINTENANCE

See Figures 42 - 43.

Tighten the mounting screw of the nose guard as instructed

below. These are specially hardened screws. If the screw

cannot be installed tightly, replace both the screw and the

SAFE-T-TIP

before further operation. Do not replace with

an ordinary screw.

In addition to preventing chain contact with solid objects at

the nose of the bar, the SAFE-T-TIP

also helps keep the

chain away from abrasive surfaces such as the ground. Keep

it on the right hand side of the bar, where it will be between

the chain and the ground during flush with ground cutting.

The mounting screw requires a 5/16 in. wrench (or adjustable

wrench) to achieve the recommended tightness of 35 to 45

in. lb. A tightness within this range can be achieved by the

following method.

n Tighten the screw with your finger.

n From the finger-tight position, tighten the screw an ad-

ditional 3/4 of a turn using a wrench.

MOUNTING SAFE-T-TIP

NOSE GUARD

See Figures 42 - 43.

n Mount the SAFE-T-TIP

on the bar nose.

NOTE: The tab fits in the recessed hole in the bar.

n Tighten the screw with your finger.

n From the finger-tight position, tighten the screw an ad-

ditional 3/4 of a turn using a wrench.

TRANSPORTING AND STORING

See Figure 44.

n Do not store or transport the chain saw when it is running.

The chain saw should always be idle before storing or

transporting.

n Always place the guide bar scabbard on the bar and chain

before storing or transporting the chain saw. Use caution

to avoid the sharp teeth of the chain.

n Clean the chain saw thoroughly before storing. Store the

chain saw indoors, in a dry place that is locked and/or

inaccessible to children.

n Keep away from corrosive agents such as garden chem-

icals and de-icing salts.

WARNING:

Although the guide bar comes with a SAFE-T-TIP

anti-

kickback device already installed, you need to check the

tightness of the mounting screw before each use.

TIGHTEN 3/4

OF A TURN

MOUNTING SCREW

SAFE-T-TIP

LOCKING RIVET

Fig. 42

Fig. 43

MAINTENANCE

Fig. 44

SCABBARD

CHAIN

BAR

1 2 ... 22 23 24 25 26 27 28 29 30

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY43006 Manuel d'utilisateur Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Outil à essence Ryobi RY43006