Ryobi C122D Manuel d'utilisateur télécharger pdf (Page 7)

7 − English

OPERATION

CHARGING A HOT BATTERY PACK

If the battery pack is above normal temperature range, the

red LED will begin flashing and the green LED will be off.

When the battery pack cools down to approximately 122°F,

the charger will automatically begin fast charge mode.

CHARGING A COOL BATTERY PACK

If the battery pack is below normal temperature range, the

red LED will begin flashing and the green LED will be off.

When the battery warms to a temperature of more than

32°F, the charger will automatically begin charge mode.

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

To avoid serious personal injury, always remove the

battery pack from the tool when cleaning or performing

any maintenance.

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 8

AFTER FRENCH AND SPANISH LANGUAGE SECTIONS

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal injury.

COLD WEATHER OPERATION

The lithium-ion battery pack can be used in temperatures

down to -4°F. Put the battery pack on a tool and use the tool

in a light duty application. After about a minute, the pack will

warm up and begin operating normally.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Pas de commentaire

Ryobi C122D Manuel d'utilisateur Page 7