Ryobi RY43160A Manuel de l'opérateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 60
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
Page 11 — English
Fig. 3
CONNECTING THE POLES
See Figure 3.
Before using the pole saw, a one-time assembly is
required. When removed from the box, the three
poles are connected by an electrical cord as shown
above.
Remove the four (4) rubber cord protectors
from inside the poles. This material protects the
cord during shipping and MUST be discarded
immediately.
Unscrew the lower collar from the threaded base
on the intermediate pole and push back over the
cord to the handle pole shaft as shown.
Insert the handle pole into the intermediate pole
and slide together until you hear the button click.
The tubes are egg-shaped and will only install
one way.
Lower the collar on the handle pole to the
threaded base on the intermediate pole and
rotate clockwise to secure.
Repeat this process to attach the intermediate
pole to the powerhead pole.
NOTE: Once assembled correctly, handle pole and
powerhead pole should not be able to separate
from intermediate pole when pulled. Repeat above
steps if poles can be separated from intermediate
pole.
WARNING:
Failure to lock powerhead pole as directed
above could result in serious injury or death.
HANDLE
POLE
INTERMEDIATE
POLE
THREADED BASE
LOWER
COLLAR
THREADED
BASE
POWERHEAD
POLE
UPPER
COLLAR
CORD
BUTTON
BUTTON
ASSEMBLY
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Commentaires sur ces manuels

Pas de commentaire